* State of the art technology provides exceptional reliability when working w/difficult speakers * Stable down to 2 ohm impedence * Excellent handling of low frequencies as well as clear mids & flawless highs * High output power to drive Pro. loudspeakers without distortion * Oversized toroidal transformer, filter & heatsinks for better low end, transparency & stability * Comprehensive protection circuitry (short, overheat, DC, subsonic & RF filters, turn-on delay) w/high current speaker protection relays * Three modes of operation - stereo, parallel mono & mono bridge w/mode status indication LED on front panel * Flexible input configuration w/active balanced inputs; additional input connectors to chain amps * True clip LED for better control * Front-to-Rear airflow w/2 speed dual fan control * Efficient dual aluminum extrusion heatsink design for thermal stability & reliability * Turn-on in-rush current limiting circuitry * Compact 2U well balanced enclosure * Steel reinforced chassis construction for durability & longevity * Output Power EIA: 1 kHz @ 1% THD * Single Channel 8 ohms: 190 * Both Channels Driven 8 ohms: 175 * Single Channel 4 ohms: 325 * Both Channels Driven 4 ohms: 275 * Single Channel 2 ohms: 470 * Both Channels Driven 2 ohms: 360 * Mono Bridge 8 ohms: 550 * Mono Bridge 4 ohms: 750 * Dynamic Headroom: 8 ohms: 1.3, 4 ohms: 2.3 * Frequency Response: 20 Hz - 20 kHz * Total Harmonic Distortion: less than 0.01% @ 1 kHz * Intermodulation Distortion: less than 0.02% (SMPTE) * Signal to Noise Ratio: 100 dB below rated power @ 8 ohms * Damping Factor: greater than 500 @ 8 ohms * Slew Rate: 16 V/mS * Voltage Gain: 33 dB * Input Sensitivity (for rated power at 8 Ohm): 0.82 VRMS * Input Impedance Unbalanced: 10 kohms * Input Impedance Balanced: 20 kohms * Power consumption: 550 VA * Note: power consumption is given at rated power at 8 ohms per channel, both channels driven. * AC Power Requirement (power connection is factory configured): 120V/ 60 Hz * Indicators: 1 Power Indicator, 1 Signal LED per channel, 1 Clip LED per channel, 1 Protect LED per channel, 1 Mono LED, 1 Bridge LED * Cooling: 2 Speed Dual Fan; Front-to-Rear Forced Air * Protection: Short Circuit, DC, Thermal Cut-off, Sub/ultrasonic Frequency Filters, In-rush Current Limiter, Turn-on Delay, main fuse, secondary DC supply fuses CONNECTIONS: * Balanced/Unbalanced Inputs: 1/4 TRS Jack * Balanced Inputs: XLR Female Jack * Speaker Outputs: Speakons (CH.A, CH.B & bridge) * Brand New * Full Manufacturer's Warranty |
